Boxes.py


CardBox

Box for storage of playing cards

Settings for Finger Joints

angle
style

style of the fingers

surroundingspaces

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

edge_width

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

finger

width of the fingers (multiples of thickness)

play

extra space to allow finger move in and out (multiples of thickness)

space

space between fingers (multiples of thickness)

width

width of finger holes (multiples of thickness)

CardBox Settings

h

inner height in mm

cardwidth

Width of the cards

cardheight

Height of the cards

num

number of compartments

Default Settings

thickness

thickness of the material (in mm) 🛈

format

format of resulting file 🛈

tabs

width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈

debug

print surrounding boxes for some structures 🛈

labels

label the parts (where available)

reference

print reference rectangle with given length (in mm)(zero to disable) 🛈

inner_corners

style for inner corners 🛈

burn

burn correction (in mm)(bigger values for tighter fit) 🛈



Building instructions

Place inner walls on floor first (if any). Then add the outer walls. Glue the two walls without finger joins to the inside of the side walls. Make sure there is no squeeze out on top, as this is going to form the rail for the lid.

Add the top of the rails to the sides and the grip rail to the lid.

Details of the lid and rails

Details

Whole box (early version still missing grip rail on the lid):


Поддержать проект: